Contact the Original Leak Specialist
You will be contacted promptly.
* denotes a required field. Privacy Policy:
To answer your questions or comments, Australian Leak Detection only collects personal information that you voluntary provide to us. We do not sell or share this information with any third parties outside of the ALD system.
You will be contacted promptly.
* denotes a required field. Privacy Policy:
To answer your questions or comments, Australian Leak Detection only collects personal information that you voluntary provide to us. We do not sell or share this information with any third parties outside of the ALD system.
The "Bucket Test" will determine if water loss in a pool is due to evaporation or a leak:
- Bring pool water to normal level.
- Fill bucket with pool water to about 3 cm from top.
- Place bucket on first or second step of pool.
- Mark water level on inside of bucket.
- Shut off pump and mark pool level on outside of bucket.
- Resume normal pump operation.
- After 24 hours, compare the two levels. If the pool water (outside mark) goes down more than the inside water level, there is probably a leak.
Test is not valid after 24 hours.
Leaks Found Since 1974
4,426,326
4,426,326
Locations
Tips to Use
Employment
